BioLite Net/Solo Outdoor Fingerprint IP Terminal 16 I BioEntry Plus Fingerprint IP Reader/Controller 18. Export in CSV and PDF. Voice and sound instruction with built-in speaker, and on-device navigation keys makes even easier device. Version 2.20 Download Manual Link Here: BioLite Net Installation Guide.pdf. 3 MB Download.
Suprema Inc. BioLite-NET
Suprema >
User manual
BioLite NET
User Guide (ver 1.0)
Basic Contents
EE--ringring
ra
k
t
Wall-mounting metal bracket
(optional)
12V ±10%, at least 2500mA for BioLite-NET
alone installation.
(CE Certification).
use a power supply with higher current ratings.
ⒸCopyright 2008Suprema Inc.
12V power adaptor
PINPOWER + 485WIRE
+
c
2POWER GNDBLACK
4485 +BLUE(Black String)
Power & 485
Relay
1NORMAL CLOSEORANGE(White String)
3NORMAL OPENGRAY(White String)
Ethernet
2ERX +BLUE
4ETX +PINK
PIN SWITCH&WIEGANDWIRE
2WDATA 1WHITE
4GND GRAY
6GND GRAY
3
Before Start
Recommended power supply
zTo share the power with other devices, use a power supply with higher current ratings.
ⒸCopyright 2008Suprema Inc.
5
6
7
BioLite NET
1
(2) SW0 GND (GRAY)
(4) SW1 GND (GRAY)
Re
uest To
Exit
ⒸCopyright 2008Suprema Inc.
9
10
Before Start
2
Power GND
Blac
(1) Power 12V (Red)
(2) Power GND (Black)
BioLite NET (Master)BioLite NET (Slave)
(5) TRX- (Yellow)
(3) Signal GND (White)
(5) TRX- (Yellow)
(3) Signal GND (White)
TRX-
TRX GND
na
e
erm
na
on
Secure I/O
TRX+
Secure I/O
op
ona
, see
o
e
As short as possible (Note 2)
1. For bus termination, only the devices at both ends of the bus should be terminated.
o ena
e
erm
na
on on
e
-
conver
e
, re
er
o
e conver
e
s manua
.
11
12
RTE
Switch 0Switch 0
switch
I/O
1
Internal
Door
Switch 1
Status Switch 1
ⒸCopyright 2008Suprema Inc.
ⒸCopyright 2008Suprema Inc.
item content
BLN-OC
Transmit 13.56MHz
Modulation ASK
Channel Single channel
Using RFID card(13.56MHz = Mifare model only)
zIf the 1:1 mode is set as Card Only, user can access just by placing the card to BioLite-NET
15
Secure
Relay 0
RTE
Switch 0
Door 1
Status
If you select Network on initial UI menu, Network Setup menus appear on the display.
If you select TCP/IP on network menu, following menus appear on the display.
zUsed when connected to PC via Ethernet using RJ45 connector on the rear of the device.
zSetting : 1/4/8/16
zMax number of clients that can access the device at the same time.
Max conn
_
-
.
zUsing DHCP, you can receive IP address and other necessary setting from server automatically.
zCheck whether an appropriate DHCP server is available in your network environment before use.
16
zWithout using DHCP, IP address, gateway, and subnet need to be entered manually. Inquire
IP Address, gateway, subnet
Min.Typ.Max. Notes
.
.
Current (mA)- 250
Voltage (V)2.733.3Lithium-ion rechargeable battery
Switch Input
-
Pull-up resistance (Ω)-4.7k-The input ports are pulled up with 4.7k resistors
VOH (V) -5 -
Pull-up resistance (Ω)-4.7k -
The outputs ports are open drain type, pulled up with 4.7k resistors
Relay
0.3
125V AC
30W
DC
17
Switching voltage (V)--
125
AC
ⒸCopyright 2008Suprema Inc.
Fingerprint can not be read well or it takes too long.
er or fin
er
rint sensor is stained with sweet
water or dust
zRetry after wiping off finger and fingerprint sensor with dry towel.
zIf a fingerprint is way too dry, blow on the finger and retry.
Fingerprint is entered but authorization keeps failing.
Check whether the user is restrictedby door zone or time zone
zInquire of administrator whether the enrolled fingerprint has been deleted from the device for some
Authorized but door is not opened.
.
zCheck whether an antipass back mode is in use. In antipass back mode, only who entered can exit.
Device doesn’t operate though power is connected.
zCheck whether a device and a bracket is well connected to each other. If not, a tamper switch is
’
.
zRisk of explosion if battery is replaced by an incorrect type.
zDispose of used batteries according to the instructions.
ⒸCopyright 2008Suprema Inc.
20
Fax : 82-31-783-4506
ⒸCopyright 2008Suprema Inc.
Suprema Inc. BioLite-NET
Suprema >
User manual
BioLite NET
User Guide (ver 1.0)
Basic Contents
EE--ringring
ra
k
t
Wall-mounting metal bracket
(optional)
12V ±10%, at least 2500mA for BioLite-NET
alone installation.
(CE Certification).
use a power supply with higher current ratings.
ⒸCopyright 2008Suprema Inc.
12V power adaptor
PINPOWER + 485WIRE
+
c
2POWER GNDBLACK
4485 +BLUE(Black String)
Power & 485
Relay
1NORMAL CLOSEORANGE(White String)
3NORMAL OPENGRAY(White String)
Ethernet
2ERX +BLUE
4ETX +PINK
PIN SWITCH&WIEGANDWIRE
2WDATA 1WHITE
4GND GRAY
6GND GRAY
3
Before Start
Recommended power supply
zTo share the power with other devices, use a power supply with higher current ratings.
ⒸCopyright 2008Suprema Inc.
5
6
7
BioLite NET
1
(2) SW0 GND (GRAY)
(4) SW1 GND (GRAY)
Re
uest To
Exit
ⒸCopyright 2008Suprema Inc.
9
10
Before Start
2
Power GND
Blac
(1) Power 12V (Red)
(2) Power GND (Black)
BioLite NET (Master)BioLite NET (Slave)
(5) TRX- (Yellow)
(3) Signal GND (White)
(5) TRX- (Yellow)
(3) Signal GND (White)
TRX-
TRX GND
na
e
erm
na
on
Secure I/O
TRX+
Secure I/O
op
ona
, see
o
e
As short as possible (Note 2)
1. For bus termination, only the devices at both ends of the bus should be terminated.
o ena
e
erm
na
on on
e
-
conver
e
, re
er
o
e conver
e
s manua
.
11
12
RTE
Switch 0Switch 0
switch
I/O
1
Internal
Door
Switch 1
Status Switch 1
ⒸCopyright 2008Suprema Inc.
ⒸCopyright 2008Suprema Inc.
item content
BLN-OC
Transmit 13.56MHz
Modulation ASK
Channel Single channel
Using RFID card(13.56MHz = Mifare model only)
zIf the 1:1 mode is set as Card Only, user can access just by placing the card to BioLite-NET
15
Secure
Relay 0
RTE
Switch 0
Door 1
Status
If you select Network on initial UI menu, Network Setup menus appear on the display.
If you select TCP/IP on network menu, following menus appear on the display.
zUsed when connected to PC via Ethernet using RJ45 connector on the rear of the device.
zSetting : 1/4/8/16
zMax number of clients that can access the device at the same time.
Max conn
_
-
.
zUsing DHCP, you can receive IP address and other necessary setting from server automatically.
zCheck whether an appropriate DHCP server is available in your network environment before use.
16
zWithout using DHCP, IP address, gateway, and subnet need to be entered manually. Inquire
IP Address, gateway, subnet
Min.Typ.Max. Notes
.
.
Current (mA)- 250
Voltage (V)2.733.3Lithium-ion rechargeable battery
Switch Input
-
Pull-up resistance (Ω)-4.7k-The input ports are pulled up with 4.7k resistors
VOH (V) -5 -
Pull-up resistance (Ω)-4.7k -
The outputs ports are open drain type, pulled up with 4.7k resistors
Relay
0.3
125V AC
30W
DC
17
Switching voltage (V)--
125
AC
ⒸCopyright 2008Suprema Inc.
Fingerprint can not be read well or it takes too long.
er or fin
er
rint sensor is stained with sweet
water or dust
zRetry after wiping off finger and fingerprint sensor with dry towel.
zIf a fingerprint is way too dry, blow on the finger and retry.
Fingerprint is entered but authorization keeps failing.
Check whether the user is restrictedby door zone or time zone
zInquire of administrator whether the enrolled fingerprint has been deleted from the device for some
Authorized but door is not opened.
.
zCheck whether an antipass back mode is in use. In antipass back mode, only who entered can exit.
Device doesn’t operate though power is connected.
zCheck whether a device and a bracket is well connected to each other. If not, a tamper switch is
’
.
zRisk of explosion if battery is replaced by an incorrect type.
zDispose of used batteries according to the instructions.
ⒸCopyright 2008Suprema Inc.
20
Fax : 82-31-783-4506
ⒸCopyright 2008Suprema Inc.